The X10 interface uses the Python X-10 library to talk to the X10 interfaces. While Python X10 does support the CM11/12, CM15, and CM17a interfaces, only the CM11 has been tested and functionality for the others would require minor code changes. Send a message to 'dinki' on the forums or IRC if you are interested in using these other interfaces.
The X10 device driver reads from a configuration file located at /etc/opt/agocontrol/conf.d/x10.conf:
[x10] interface=CM11 device=/dev/ttyUSB0 switches=A2,A3,B3,B4,B5,B9,B12,B16 dimmers=D1
Interface options are CM11, CM15, and CM17a. Note that the CM12 is supported using the CM11 option
Currently only switches are supported for simple on/off. These switches can be used for lamp, appliance, motion detectors, remote control buttons, etc. Dimmer support is planned but has not been implemented.
Python X-10 only supports sending X10 commands. This device driver has been given a limited, but functional access to commands received on the X10 interface via RF->Powerline communications. The device driver only recognizes on/off commands received but support for dimmer commands are planned for future releases.