RaspberryPi1Wire

From ago control wiki
(Difference between revisions)
Jump to: navigation, search
(Configuration)
m (Configuration)
 
(2 intermediate revisions by one user not shown)
Line 1: Line 1:
 
=Raspberry Pi GPIO 1-wire device=
 
=Raspberry Pi GPIO 1-wire device=
 
This devices enables the 1-wire support on GPIO pin 4 of the Raspberry Pi
 
This devices enables the 1-wire support on GPIO pin 4 of the Raspberry Pi
 +
 
= Installation=
 
= Installation=
 
  apt-get install agocontrol-raspi1w
 
  apt-get install agocontrol-raspi1w
Line 10: Line 11:
 
  interval=600 # maximum time(seconds) between reports
 
  interval=600 # maximum time(seconds) between reports
 
  change=0.2  # temperature change between reports
 
  change=0.2  # temperature change between reports
 +
 +
 +
If you have troubles to get your 1wire devices, then add this:
 +
sudo nano /boot/config.txt
 +
Add this content
 +
dtoverlay=w1-gpio,gpiopin=4
  
 
= suported sensors=
 
= suported sensors=
 
* DS18B20
 
* DS18B20
 
More may work please report
 
More may work please report

Latest revision as of 15:06, 7 February 2015

Contents

[edit] Raspberry Pi GPIO 1-wire device

This devices enables the 1-wire support on GPIO pin 4 of the Raspberry Pi

[edit] Installation

apt-get install agocontrol-raspi1w

[edit] Configuration

Configuration file is located at /etc/opt/agocontrol/conf.d/raspi1wGPIO.conf

[raspi1wGPIO]
interval=600 # maximum time(seconds) between reports
change=0.2   # temperature change between reports


If you have troubles to get your 1wire devices, then add this:

sudo nano /boot/config.txt

Add this content

dtoverlay=w1-gpio,gpiopin=4

[edit] suported sensors

  • DS18B20

More may work please report

Personal tools