Main Page

From ago control wiki
Revision as of 21:50, 28 October 2013 by Dinki (Talk | contribs)

Jump to: navigation, search


What is ago control?

ago control is a framework for device control. The aim is to provide a complete home automation solution. It can also be used in other areas, like agriculture. ago control uses an AMQP Enterprise Message Bus as communication backend, a lightweight protocol, readable by humans and machines, modern and modular architecture, cloud features and more!

ago control boasts great performance and also runs on embedded devices like the Raspberry Pi and multiple plug computes like Sheevaplug, Guruplug and Pogoplug. It has support for many devices and protocols like Z-Wave, KNX, EnOcean, X10, 1wire, Asterisk PBX, Dreambox/Enigma2, Onkyo eISCP AVR, Chromoflex USP3 RGB LED dimmer, APC Power Distribution Unit (PDU), DMX Interfaces via the OpenLightingArchitecture (OLA), Phillips TV sets (Jointspace), Arduino Firmata, IRTrans Ethernet consumer infrared blaster, Kwikwai HDMI CEC Ethernet bridge, Rain8net irrigation controller, Webcam support, and BlinkM LED support. ago control is easy to extend and has a growing list of user submitted device drivers.

Getting started




Device Specific

  • Z-Wave Basics - The basics about setup, inclusion, association and parameters of a Z-Wave device
  • Asterisk Basics - Set up Asterisk PBX with ago control in 5 Minutes

System overview

Core Components

Listed below are the various components that monitor and act upon system variables and various input devices configured within the ago control system:

Device Interfaces

Development Notes

Example Setups

Personal tools